Print everything without supports EXCEPT the lens frames. The face shell and lens includes holes for round circular magnets, of the following diameters. 4x of 6mm 4x of 8mm Thickness should be 2-3mm Trim mesh into the lens clips as needed. Sand down the face shell for comfort. All sticking was done with Gorilla Glue and a soldering iron, but it can be done with any type of super glue. There is a red mask over the shell. I will do the black web designs later with black fabric glue or hot glue. I had a lot of trouble when printing because of the holes, so MAKE SURE ADHESION IS ON. This will save you a lot of filament, trust me. If you are trying to save filament, don't print “spiderman_1_head_2_opt”. It is not extremely necessary, but would be nice and snug to have. Credit: RooShoo Good luck and ask questions!

Spider-Man Faceshell

by Advotor · original on MakerWorld ↗

♥ 862⬇ 1.5k🖨 513 prints

License: BY-NC-SAspidermanmaskfaceshellSpiderSpidermanheadCOSPLAYcostume accessoryMarvel

Print profiles

Spider-Man Faceshell
⏱ 16h 3m · 201 g · 2 material(s)
Prints on: A1 0.4, X1 0.4, X2D 0.4, X1E 0.4, P1S 0.4, H2C 0.4, X1 Carbon 0.4, H2D Pro 0.4, P2S 0.4, A2L 0.4, H2S 0.4, P1P 0.4, H2D 0.4PLAPLA
Not printable on our printers