Fully functional iron spider web shooter from like ¾ of the movies Tom Holland's spiderman is in. I designed it to work with about 2-3 smallish rubberbands. ASSEMBLY: Remove all support. Should be reasonably obvious. Take one rubber band and wrap it from one cylinder underneath the little palm firing mechanism. If you did it right, it should pop back up when you push it down and look like this: 3. Take 1-2 rubber bands and feed them through the rectangular hole in the barrel, then hook both ends around the same 2 cylinders you used in step 2. It should look like this: 4. Take a web cartridge (shown in white). Push down on the palm and feed the cartridge into the barrel groove side first, making sure to get the rubber bands into the groove. Before letting go of the cartridge, make sure to release the palm, or else it'll fly out and you'll be right back where you started. 5. Press down on the palm and fire! I'd recommend printing bigger than the sizing bracelet I attached fits on you and putting some foam on the inside to make it easier to fire. If you don't have anything like that, you can always just brace it with your other hand to fire. Happy Web Slinging!

Functional Spiderman Web Shooter (Iron Spider)

by Shrek · original on MakerWorld ↗

♥ 561⬇ 686🖨 197 prints

Print profiles

• Default

  ⏱ 14h 23m · 251 g · 1 material(s)

  Prints on: A1 0.4, P1S 0.4, P1P 0.4, X1 Carbon 0.4, X1E 0.4, X1 0.4, H2D 0.4, H2D Pro 0.4, H2S 0.4, P2S 0.4, H2C 0.4, X2D 0.4, A2L 0.4PLA

  Not printable on our printers