"…the Grogfin is sure to make both ground and sea travel a breeze for Ugtopian citizens." - Dinodex, official UG Discord. Grogfin - Hydro 05 Unfortunately. After many, many, failed tests, I found that the Grogfin's tiny little whiskers are too small to be printed without snapping off when removed from the plate. This model, therefore, is technically… a bald Grogfin. I am sorry. Use PETG or ABS for this model, PLA will cause the joints to loosen in a few days and is reportedly prone to cracking. * DON'T USE IT! You might need clippers to remove or clean up some of the small supports, but most of them can be taken off normally. I would recommend sanding or smoothing down rough edges on the joints if you have difficulty fitting them together. (Like on the arms). Please leave the parts in their current orientations, they're arranged so the sockets print properly. Make sure to have good bed adhesion for a successful print (lots of pieces spread across a bed can be difficult for printers.)

Grogfin - UG VR

by Cosmic_Egg · original on MakerWorld ↗

♥ 44⬇ 15🖨 21 prints

Print profiles

• A1 Mini

  ⏱ 2h 29m · 26 g · 1 material(s)

  Prints on: A1 mini 0.4, P2S 0.4, H2D Pro 0.4, X2D 0.4, A2L 0.4, A1 0.4, H2D 0.4, P1S 0.4, X1E 0.4, X1 Carbon 0.4, H2S 0.4, X1 0.4, H2C 0.4, P1P 0.4PETG

  Not in stock

• 0.16mm layer, 2 walls, 15% infill

  ⏱ 2h 4m · 26 g · 1 material(s)

  Prints on: P1S 0.4, X1E 0.4, P2S 0.4, H2C 0.4, H2D 0.4, A2L 0.4, X1 Carbon 0.4, A1 mini 0.4, X2D 0.4, H2D Pro 0.4, P1P 0.4, H2S 0.4, X1 0.4, A1 0.4PETG

  Not in stock