Upgrade your adaptive manufacturing setup with the K3M Deflector , a purpose-built waste shield designed specifically for the Anycubic Kobra 3 Max. During high-volume multi-color prints or standard toolhead purges, filament can occasionally flick or bounce outside of your collection zone. This deflector catches those erratic extrusions and channels them straight down. Zero-Hardware Installation: Installation is incredibly fast and simple. This deflector is precision-engineered to mount directly to the chassis using the already existing factory screws . No need to buy extra hardware, nuts, or bolts! Simply back out the stock screws, align the deflector's mounting holes, and re-tighten them for a rigid, rock-solid fit. Two Ways to Use: The Ultimate Combo: This deflector was engineered as the perfect companion upgrade to the high-capacity K3M Poo Chute and Bin . Paired together, you get a fully enclosed, zero-miss waste management system. Standalone Print: Already have a custom bucket or chute? No problem. This deflector prints and functions perfectly as a standalone shield to improve the reliability of your own custom K3M waste setup. Design Highlights: Precision Deflection: Angles hot purge lines downward, preventing side spatter or desk buildup. 🎯 Uses Existing Screws: Mounts securely using the stock hardware already on your printer. 🔩 Multi-Platform Ready: Fully optimized for users on both MakerWorld and MakerOnline. 🌐 Recommended Print Settings Because this part sits near the heated nozzle and catches freshly extruded filament, temperature-resistant materials are highly recommended. Material: PETG , ABS , or ASA (PLA can be used, but may warp over time if warm purge material builds up against it). Layer Height: 0.20mm for a strong, fast functional print. Walls / Perimeters: 3 to 4 Wall Loops to ensure structural rigidity at the mounting points. Infill: 15–20% Grid or Gyroid. Supports: Minimal supports may be required depending on your printing orientation (printing flat on the wide face is recommended). If you enjoyed printing this, a Like or a Boost would be appreciated. 🙌

Anycubic Kobra 3 Max Purge Waste Shield

by Troy · original on MakerWorld ↗

♥ 2⬇ 2🖨 4 prints

Print profiles

• 0.2mm layer, 3 walls, 20% infill

  ⏱ 46m · 16 g · 1 material(s)

  Prints on: A1 0.4, X1E 0.4, P2S 0.4, H2C 0.4, H2D 0.4, A2L 0.4, X1 Carbon 0.4, A1 mini 0.4, X2D 0.4, H2D Pro 0.4, P1P 0.4, H2S 0.4, X1 0.4, P1S 0.4PLA

  Not in stock