Hey Guys, Made a controller stand for dual sense for PS5 since i could not find a ONI style controller which can support 2 controllers. I had already made which can support 1, but that meant the other controller was a travelling nomad going from sofa's to kitchen. :D This controller stand has good fitting for both controllers, compact size and enough clearance to hold 2 controllers nice and tight. It is easy to pick up any controller and charge both of them together as well. Print settings: 10-15% Infill. ideally grid. You can experiment if needed, should not have an impact. 3 walls 0.2 -0.28mm layer height No supports required. Slicer might through error for overhang, you can ignore those. Profiles : NO AMS Profile Contains 2 models with the main controller holder being one color and the nose ring as a new color in separate beds so you can print them in different colors. You can use any single color printer for these. No need for multicolor switch. AMS Profile Requires AMS for the main controller holder to switch between 2 colors. The nose ring is printed separately and is provided in the same file on another bed. If you want the ONI controller stand with 1 controller holder you can check this below LINK

ONI Dual Controller Stand PS5

by Faster Caster · original on MakerWorld ↗

♥ 13⬇ 15🖨 9 prints

Print profiles

• NO AMS Profile - All printers

  ⏱ 5h 33m · 232 g · 2 material(s)

  Prints on: A1 mini 0.4, X1E 0.4, P2S 0.4, H2C 0.4, H2D 0.4, A2L 0.4, X1 Carbon 0.4, X2D 0.4, H2D Pro 0.4, P1P 0.4, H2S 0.4, X1 0.4, P1S 0.4, A1 0.4PLAPLA

  Not in stock