Boost Me Boost me so I can keep making awesome models! Every boost helps me keep creating! I used Shapr3D to create this model, and it was definitely a bit of a struggle! This was my first time making a 3D model with Shapr3D, and the design itself was also a little tricky to figure out. After getting some feedback, I’m currently redesigning the model and making some improvements. I’ll post the updated version in a separate post once it’s finished. Magnetic Design To make this model magnetic, I used 5 magnets from Amazon. The magnets I used are 10x2mm. Also I printed this print using PLA Pure and it was my first time using it. I would rrecomend doing it is just normal PLA though because the print wasn't as good with PLA pure. One thing to note: when installing the magnets, I recommend putting a small amount of super glue underneath them to help keep them securely attached to the print. You don't necessarily have to use glue, but without it, there is a chance that a magnet could come out when you pull the holder off of a magnetic surface. Here is a link to a fairly priced magnet set: amazon.com/Magnets-Refrigerator-Neodymium-Whiteboard-Kitchen

Magnetic Pencil Holder

by Londofundo · original on MakerWorld ↗

♥ 3⬇ 0🖨 2 prints

Print profiles

• 0.2mm layer, 2 walls, 15% infill

  ⏱ 2h 20m · 52 g · 1 material(s)

  Prints on: P1P 0.4, P1S 0.4, X1 Carbon 0.4, X1 0.4, P2S 0.4, A2L 0.4, H2D Pro 0.4, H2D 0.4, A1 mini 0.4, H2S 0.4, X2D 0.4, X1E 0.4, A1 0.4, H2C 0.4PLA

  Not in stock