3' Foot Candy Cane Lawn Ornament This is an adapted version of my LED Candy Cane. I had some people reach out and say they wanted a version without the holes to use as a stand alone decoration. I reworked the dovetails so they are only visible on the back side of the prop. That does mean this print is directional. Also to avoid requiring supports, the Red gets printed face down and will pick up the texture of the bed. The white gets printed face up and has ironing turned on to help smooth the face. I have also included a “classic dove tail” version that has the dove tails right through it. I have included clips that can be printed that snap around the candy cane and clips to ½" PVC Conduit. That can either be pushed directly into the snow or slipped over a piece of rebar pounded into the ground. This print also scales well. I printed one at 35% which gets you a ~12" Candy Cane. The PVC clip will not work if scaled. This prop prints in ~20 hours and uses around 275 grams of White PETG and 320 grams of Red PETG. Check out the LED version here: https://makerworld.com/en/models/2151283-3-foot-led-candy-cane-150-pixels

3 Foot Candy Cane Lawn Ornament

by guyfromcanada · original on MakerWorld ↗

♥ 7⬇ 2🖨 4 prints

Print profiles

• Candy Cane - Hook Right

  ⏱ 20h 58m · 597 g · 2 material(s)

  Prints on: A1 0.4, H2S 0.4, P2S 0.4, H2C 0.4, H2D Pro 0.4, A2L 0.4, H2D 0.4, X2D 0.4PETGPETG

  Not printable on our printers

• Candy Cane - Hook Left

  ⏱ 20h 58m · 597 g · 2 material(s)

  Prints on: A1 0.4, H2S 0.4, P2S 0.4, H2C 0.4, H2D Pro 0.4, A2L 0.4, H2D 0.4, X2D 0.4PETGPETG

  Not printable on our printers

• Candy Cane - Classic Dovetail

  ⏱ 17h 3m · 591 g · 2 material(s)

  Prints on: A1 0.4, X1E 0.4, X1 0.4, P2S 0.4, H2D Pro 0.4, P1P 0.4, X1 Carbon 0.4, H2D 0.4, P1S 0.4, H2C 0.4, X2D 0.4, A2L 0.4, H2S 0.4PETGPETG

  Not printable on our printers