什么？你家的门也比 IKEA ENUDDEN 厚了一些吗！ 家里的门板比宜家 ENUDDEN 原装挂架所支持的厚度稍厚，无法正常安装，于是我设计并打印了这套替换夹具。 打印后，将 ENUDDEN 两端原有的固定零件替换为这套夹具，即可把挂架安装在别处，例如隔板、抽屉或其他合适的位置。夹具采用螺纹旋钮固定，可以根据板材厚度进行调节，也不需要在门板上钻孔。使用 ENDUDDEN 自带的螺丝即可，甚至不需要使用螺丝刀。 我提供的打印文件中包含了两套一共四个夹具，不同的打印底面选择会导致打印强度略微不同，建议一次性打印全部以便获得最满意的强度和质量。 IKEA ENUDDEN https://www.ikea.com/gb/en/p/enudden-hanger-for-door-white-60251665/ What? Is your door a little too thick for the IKEA ENUDDEN too? The door in my home was slightly thicker than the ENUDDEN’s original brackets could accommodate, so I designed and printed these replacement clamps. Simply replace the original mounting parts at both ends of the ENUDDEN with these clamps. This allows you to install it in other places, such as on a shelf, drawer front, or another suitable panel. The threaded knobs make the clamps adjustable for different panel thicknesses, with no drilling required. They use the screws included with the ENUDDEN, so you do not even need a screwdriver. The print file contains two complete sets—four clamps in total. The two sets use different orientations on the print bed, which may result in slightly different strength and surface quality. I recommend printing all four so you can choose the pair with the strength and finish you prefer. IKEA ENUDDEN https://www.ikea.com/gb/en/p/enudden-hanger-for-door-white-60251665/

IKEA ENUDDEN Clamps

by 生锈的不锈钢 · original on MakerWorld ↗

♥ 8⬇ 3🖨 1 prints

Print profiles

• 0.16mm layer, 3 walls, 10% infill

  ⏱ 4h 54m · 79 g · 1 material(s)

  Prints on: A1 mini 0.4, X1 Carbon 0.4, X1E 0.4, H2D Pro 0.4, H2S 0.4, H2D 0.4, P2S 0.4, H2C 0.4, A2L 0.4, P1S 0.4, A1 0.4, X1 0.4, X2D 0.4, P1P 0.4PLA

  Not in stock