READ BEFORE PRINTING I DO NOT TAKE ANY RESPONSIBILITY FOR DAMAGES ETC. WARNING: CAPS PRODUCE A LOUD BANG, HOT GASES AND POSSIBLE DEBRIS. USE ONLY COMMERCIAL TOY CAPS. NEVER USE AMMUNITION, GUNPOWDER, OTHER PYROTECHNICS OR PROJECTILES. WEAR EYE AND HEARING PROTECTION. NEVER POINT AT PEOPLE OR ANIMALS. DO NOT LOAD CAPS DURING ASSEMBLY, ADJUSTMENT OR REPAIR. Inspect the print before every use Boost Me Boost me if you want to, i dont know what it does lol Stop using it immediately if any part cracks, deforms or malfunctions. NOT FOR UNSUPERVISED USE BY CHILDREN. This is a model i made, it uses normal caps. I printed it in PLA, i do not guarantee other filaments will work. It uses also an m2 screw, and about 2 rubber bands. Maybe you can exchange the rubber bands for a spring, i didnt have one so i didnt do it. ASSEMBLY TUTORIAL: Screw the screw (lol) into the “bolt”. Slide the two barrel sections together so the “ears” line up. The single ear must be in between the two other ears. Then insert the pin in the holes of the ears. Insert the bolt into the back piece of the barrel, close it and put on the rubber bands. The last circle (or something) part goes onto the front barrel, i made it so it has that “click” and it more or less stops the barrel from going up after the explosion. Insert the casing into the barrel and put on the cap. (idk what to write here) (i dont also care if you want to sell it, i just dont take any responsibility)

Cap Gun With Cartridges

by rakomotywa · original on MakerWorld ↗

♥ 8⬇ 13🖨 12 prints

License: BYcap gungunpistoltoy guncap

Print profiles

0.2mm layer, 4 walls, 100% infill
⏱ 2h 0m · 50 g · 1 material(s)
Prints on: P2S 0.4, X1E 0.4, H2C 0.4, H2D 0.4, A2L 0.4, X1 Carbon 0.4, A1 mini 0.4, X2D 0.4, H2D Pro 0.4, P1P 0.4, H2S 0.4, X1 0.4, P1S 0.4, A1 0.4PLA
Not in stock