Here is a mod that I made for the Moza RS V2 using a VoCore screen. This replaces the faceplate on the front of the Moza RS V2 that says MOZA Racing. I recommend a very long or springy USB cable. The cutout I have used fits the USB cable I had lying around. You will need a VoCore 4" screen as well as the USB C cable. No other hardware required. A USB extension could be a good idea to mount to your rig as a breakaway and making the wheel easier to install onto as the USB will need to be plugged in as well as the wheel. To install: Take the three Allen bolts out of the faceplate. These are very long screws, and we will be reusing them On the VoCore screen, I wrapped the usb board with Kapton tape. I don't think this is required, but as the internals are exposed and the wheel is conductive, it is good practice. Install the back part of the mod, fit the board in place and fold the screen down into the frame. NOTE: the screen is installed upside down due to the way that the USB board fits: Once in place, add the front part of the frame on top, no additional screws required: If you don't already, download SimHub, and I recommend Lovely Dashboards (I am not affiliated with them!) A very long USB is required so that you don't unplug the screen. The sticks have slightly less travel than before but do still work in all directions. #MOZACreatorContest

Moza RS v2 vocore 4" screen mod

by thetartanbananaas · original on MakerWorld ↗

♥ 1⬇ 0🖨 0 prints

Print profiles

• 0.2mm layer, 2 walls, 15% infill

  ⏱ 42m · 25 g · 1 material(s)

  Prints on: P1S 0.4, H2D Pro 0.4, A2L 0.4, H2S 0.4, H2D 0.4, A1 mini 0.4, H2C 0.4, X1 Carbon 0.4, P2S 0.4, X2D 0.4, P1P 0.4, X1 0.4, X1E 0.4, A1 0.4PLA

  Not in stock