Sloped Faucet Mat Riser – 360x135mm, 10mm Lift (Ø65mm Center, 2 mm Slope) KEA Sink PLA Mat Riser – Say Goodbye to Stagnant Water The Problem: Silicone faucet splash guards (not included) are great for protecting countertops, but on many popular IKEA sinks and vanity tops, water tends to pool underneath or fail to drain properly due to the flat edge profile. Moisture gets trapped, leading to limescale buildup, mold, and constant manual wiping. The Solution: This custom low-profile riser elevates your silicone mat (not included) by 1 mm and introduces a transverse slope along the width. This subtle angle relies on gravity to guide splashes directly back into the basin, keeping the underside dry and well-ventilated without altering the clean look of your kitchen or bathroom. Key Specifications & Compatibility: Footprint: 360x135mm (fits standard IKEA silicone drainage mats and sink edges) Faucet Cutout: 65 mm center hole (compatible with standard faucet bases) Elevation: 10 mm rise Drainage Profile: 2 mm transverse slope along the 135 mm width 2 pieces that can be easily assembled Recommended Print Settings: Material: PETG or ASA (recommended for moisture and soap resistance; avoid PLA if possible for wet zones) Walls / Perimeters: 3 to 4 (ensures watertightness) Infill: 15–20% (Gyroid recommended)

Elevated Faucet Splash Guard Riser – 360x135x10mm

by efm · original on MakerWorld ↗

♥ 0⬇ 0🖨 0 prints

Print profiles

• 0.2mm layer, 2 walls, 15% infill

  ⏱ 2h 31m · 132 g · 1 material(s)

  Prints on: P2S 0.4, H2S 0.4, X1 0.4, X1E 0.4, X2D 0.4, P1P 0.4, A1 0.4, H2C 0.4, H2D Pro 0.4, A2L 0.4, P1S 0.4, X1 Carbon 0.4, H2D 0.4PLA

  Not printable on our printers