A SAB Goblin drinks coaster. 2 separate prints for the coaster and the logo, just push the logo parts into the coaster. The smaller lines may need a small amount of super glue to stop them from flexing upwards, the rest of the parts should just tap in! I recommend the back of a screwdriver to lightly tap it in to prevent damaging the smaller parts. Enjoy!

SAB Drinks Coaster

by Luke2001 · original on MakerWorld ↗

♥ 0⬇ 0🖨 1 prints

Print profiles

• 0.2mm layer, 2 walls, 15% infill

  ⏱ 3h 15m · 66 g · 3 material(s) · needs AMS

  Prints on: X2D 0.4, H2D Pro 0.4, A2L 0.4, P1S 0.4, H2S 0.4, H2D 0.4, H2C 0.4, X1 Carbon 0.4, P2S 0.4, P1P 0.4, X1 0.4, X1E 0.4, A1 0.4PLAPLAPLA

  Not printable on our printers