Square Golf Omni - Protective Button Shield & Cover Protect your Square Golf Omni Launch Monitor from errant shots and shanked balls! [ 1 ] Many users online have reported that the top buttons on the Square Golf Omni can break or get damaged if struck directly by a golf ball. This custom-designed protective cover is built specifically to address that issue, offering peace of mind during heavy indoor simulator sessions. Features Ball-Proof Geometry: The precise center cutout allows full access to the Bluetooth, Power, and Mode buttons. However, the opening is engineered to be smaller than a standard golf ball , ensuring a ball can never pass through to smash the physical buttons underneath. Full Accessibility: You can still easily turn the device on/off, change modes, and view status indicators without needing to remove the guard. Snug Friction Fit: Designed to slip right over the top housing of the unit seamlessly. No tape, screws, or modifications required. Low Profile: Complements the sleek aesthetic of the Square Golf Omni tower without obstructing the camera lenses or the built-in data display. Print Settings (Recommended) Material: PETG or TPU (for maximum impact absorption and shatter resistance). High-infill PLA+ will also work well. Infill: 25% or higher (Grid or Gyroid for strength). Walls: 3–4 perimeters to withstand strong golf ball impacts. Supports: Not required if printed top-face down.

Square Omni Button Cover

by AlRFORCE1 · original on MakerWorld ↗

♥ 5⬇ 13🖨 11 prints

Print profiles

• 0.2mm layer, 2 walls, 15% infill

  ⏱ 57m · 29 g · 1 material(s)

  Prints on: X2D 0.4, P1S 0.4, X1 0.4, X1 Carbon 0.4, H2D Pro 0.4, H2D 0.4, P2S 0.4, A1 mini 0.4, X1E 0.4, H2C 0.4, A2L 0.4, A1 0.4, H2S 0.4, P1P 0.4PETG

  Not in stock