Project: Nightwing.hfp Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 156x234mm in size You may print at higher layer heights below the Base Thickness of 0.88mm The Max allowed Thickness is 3.04mm and the Actual Thickness is 2.96mm #000000 PLA BambuLab Basic Black Transmission Distance: 0.1 #4c5f71 PLA BambuLab Basic Blue Gray Transmission Distance: 3 #ffffff PLA BambuLab Basic Jade White Transmission Distance: 5.8 #0086d6 PLA BambuLab Basic Cyan Transmission Distance: 2.4 #c00d1e PLA BambuLab Basic Red Transmission Distance: 3.7 #fce300 PLA BambuLab Basic Yellow Transmission Distance: 5.2 This print uses 6 unique filaments Swap Instructions: Start with Black At layer #11 (0.96mm) swap to Blue Gray At layer #14 (1.2mm) swap to Jade White At layer #16 (1.36mm) swap to Black At layer #17 (1.44mm) swap to Cyan At layer #20 (1.68mm) swap to Jade White At layer #28 (2.32mm) swap to Black At layer #29 (2.4mm) swap to Red At layer #33 (2.72mm) swap to Yellow At layer #34 (2.8mm) swap to Jade White for the rest. For single AMS users, start with 4 colors as follows, Slot1: Black SLot2: Blue Grey Slot3: White Slot4: Cyan Pause was set at Layer 21 to allow color swap: Slot2: Blue Grey --> Red Slot4: Cyan --> Yellow

Nightwing DC hueforge

by FantasyZ · original on MakerWorld ↗

♥ 12⬇ 1🖨 1 prints

Print profiles

• 0.08mm layer, 1 walls, 100% infill

  ⏱ 3h 25m · 62 g · 6 material(s) · needs AMS

  Prints on: P1S 0.4, H2D Pro 0.4, H2D 0.4, H2S 0.4, X1 0.4, H2C 0.4, A2L 0.4, X1E 0.4, X1 Carbon 0.4, P1P 0.4, A1 0.4, P2S 0.4, X2D 0.4PLAPLAPLAPLAPLAPLA

  Not printable on our printers