A two-part spinning water-blaster target. Aim at the upper face, flip the grin to the dizzy face, and race your friends. One plate, one filament, no supports and no extra hardware. Turn a water blaster into a quick backyard challenge. Splash Flip has a grin on one end and a dizzy face on the other. Aim a short burst at the upper face and try to flip the other one to the top. The design uses only two printed parts : a broad stand and a face paddle with integral axle ends. Drop the paddle into the two open slots and it is assembled. The larger end stops keep it centred. Lift it out again for drying or storage.

Tiny target. Big splash.

by Shain · original on MakerWorld ↗

♥ 2⬇ 1🖨 5 prints

License: BY-NC-SAwaterfightwatertargetwaterblastertargetgameoutdoorplaysplashspinningtargettwopartseasyprintsupportfreeadvancedwaterfight

Print profiles

0.2mm layer, 3 walls, 15% infill
⏱ 1h 19m · 29 g · 1 material(s)
Prints on: P1S 0.4, H2S 0.4, X1 0.4, X1E 0.4, P2S 0.4, P1P 0.4, X2D 0.4, A1 0.4, H2D Pro 0.4, H2C 0.4, A2L 0.4, A1 mini 0.4, X1 Carbon 0.4, H2D 0.4PLA
Not in stock