KA-BAR Build Plate Scraper Tool Tired of boring printer tools? Try out this KA-BAR bed scraper for getting stuck-on parts from your build plate surface. Print in any color you wish. What I did in the photos was print the blade and guard in black, and then the handle in brown. I then just took a sharpie and drew in the black lines. Or you could set color swaps at each layer point, or even a manual color swap/pause by layer if you don't have an AMS. I think the sharpie/paint black lines look just fine though. Enjoy!

KA-BAR Build Plate Scraper Tool - No AMS

by Design Jake · original on MakerWorld ↗

♥ 6⬇ 6🖨 1 prints

Print profiles

• 0.2mm layer, 3 walls, 15% infill

  ⏱ 2h 1m · 42 g · 1 material(s)

  Prints on: P2S 0.4PLA

  Not printable on our printers