Child Proof Light Switch Cover - 30 minute print, 1 minute install! Fits standard USA toggle light switches. Simply remove the two screws, place cover over screw holes, and screw it down. Use the included key to turn the switch on or off. For faster pring and easier support removal, print upright as shown. If you would like a smother surface, simply rotate the switch cover 90 degrees.

Child Proof Light Switch Cover

by Design Jake · original on MakerWorld ↗

♥ 67⬇ 63🖨 108 prints

Print profiles

• 0.2mm layer, 2 walls, 15% infill

  ⏱ 29m · 9 g · 1 material(s)

  Prints on: P2S 0.4, X1E 0.4, X1 0.4, H2D Pro 0.4, P1P 0.4, A1 0.4, X1 Carbon 0.4, A1 mini 0.4, H2D 0.4, P1S 0.4, H2C 0.4, X2D 0.4, A2L 0.4, H2S 0.4PLA

  Not in stock