I built a hanger clip that goes perfectly on the Ikea BEKVÄM shelf. It can be used to hang keys or even heavier objects as it is very sturdy. To make sure that it does not move when you pull the keys away I included a screw that clamps into the shelf itself, when screwed in it is almost invisible. I think it could be used without the screw too, but i like the extra toughness. This was printed in ABS but PLA should be just fine

Keys hook for IKEA BEKVÄM

by weistra.davide · original on MakerWorld ↗

♥ 0⬇ 1🖨 0 prints

Print profiles

• 0.2mm layer, 2 walls, 15% infill

  ⏱ 21m · 6 g · 1 material(s)

  Prints on: P1S 0.4, H2S 0.4, X1 0.4, X1E 0.4, P2S 0.4, P1P 0.4, X2D 0.4, A1 0.4, H2D Pro 0.4, H2C 0.4, A2L 0.4, A1 mini 0.4, X1 Carbon 0.4, H2D 0.4ABS

  Not in stock