What is it? If you have Fiskar's Waterwheel product, you probably know that rolling up the hose is not very easy because of the very small knob. This model replaces the original with an actual handle, that is bigger, easy to grip and has nice texture on it. I have a Waterwheel L, but the same knob design is also used on a smaller Waterwheel. The model is done by me and the texture is added with BumpMesh tool. What do I need? Nothing. No extra hardware. The handle is a direct replacement. Printing instructions I have included 2 ways to print in the 3mf file: Either print it in one piece (requires supports, included in profile) Or print it in two pieces and simply glue the top on later (no supports) Or you could not even print the top, but that might leave a sharp-ish edge. I recommend at least 4 walls and 25% infill, as in the included profile. Installing instructions Screw off the old knob from underneath (might require unwrapping some hose) Use the same screw to screw on the new one. Make sure to keep the screw as straight as you can!

Improved handle for the Fiskars Waterwheel

by Andrek · original on MakerWorld ↗

♥ 0⬇ 1🖨 0 prints

License: Standard Digital File Licensehoseroll up hosewaterhosewater hosegrip

Print profiles

0.2mm layer, 4 walls, 25% infill
⏱ 5h 17m · 105 g · 1 material(s)
Prints on: P1S 0.4, H2D Pro 0.4, A2L 0.4, H2S 0.4, H2D 0.4, A1 mini 0.4, H2C 0.4, X1 Carbon 0.4, P2S 0.4, X2D 0.4, P1P 0.4, X1 0.4, X1E 0.4, A1 0.4PETG
Not in stock