“…the icy Cryodon seems menacing - but is actually more cunning…” -Dinodex, official UG VR Discord. Cryodon - Titan 03 The Cryodon took over the Crystal Cave last year, and it seems like it plans to do it again… Sand down or make sure to thoroughly remove ALL supports on the joints (especially the arms) if they get stuck or fall off. Make sure to have good bed adhesion for a successful print (lots of pieces spread across a bed can be difficult for printers.) You might want clippers or a small poking tool to remove and clean up supports. Use PETG or ABS for this model, PLA will cause the joints to quickly become floppy.

Cryodon - UG VR

by Cosmic_Egg · original on MakerWorld ↗

♥ 77⬇ 36🖨 52 prints

Print profiles

• 0.16mm layer, 2 walls, 15% infill

  ⏱ 3h 53m · 48 g · 1 material(s)

  Prints on: P1S 0.4, H2D 0.4, H2C 0.4, H2D Pro 0.4, X2D 0.4, X1 0.4, A2L 0.4, X1E 0.4, A1 0.4, X1 Carbon 0.4, P1P 0.4, H2S 0.4, P2S 0.4PETG

  Not printable on our printers

• A1 Mini

  ⏱ 4h 25m · 47 g · 1 material(s)

  Prints on: A1 mini 0.4, X1 Carbon 0.4, X1E 0.4, H2C 0.4, P2S 0.4, A2L 0.4, P1S 0.4, P1P 0.4, A1 0.4, H2S 0.4, X1 0.4, H2D 0.4, X2D 0.4, H2D Pro 0.4PETG

  Not in stock