I designed a minimalist four joint/cigar container with a Bic lighter slot. The lid snaps shut firm and secure and is held to the body with a set of overkill hinges. The container can hold up to four 1gramers or any size joint/cigar less than 3.75" in length and 0.5" in diameter. NOT smell proof The latch that secures the lid shut will wear down overtime, but it takes a good amount of use before wearing down. (working on improving) Assembly Instructions: Step 1 - Align the lid hinges with the body hinges and secure the lid in the shut position, this will make inserting the filament pin easier. Step 2: Cut a 5in section of standard 1.7mm diameter filament of your choosing and begin inserting it into one side of the hinge. This may be difficult when just using your fingers, a pair of needle nose pliers will be helpful. Use the pliers to grip the filament near the hinge and push filament into the hinge. Step 3: Pass the filament through the hinge until about 1mm of filament is sticking out the other side. Then heat stake the end. I used an old flat head screwdriver and micro torch. I heat the flat head with the torch and then press the filament end flat like using a iron. Step 4: Trim the other end of the filament leaving about 1mm sticking out (keep remaining filament for other side hinge). Repeat the heat staking operation. I use my thumb to support the end that I previously heat staked so it doesn't push out. Step 5: Repeat process 1- 4 on the second hinge and enjoy. Smaller version here : https://makerworld.com/en/models/2187778-joint-case-small#profileId-2375133

Stash Case - Large

by TupperwareIV · original on MakerWorld ↗

♥ 1.9k⬇ 3.2k🖨 2.6k prints

Print profiles

• 0.16mm layer, 2 walls, 15% infill

  ⏱ 2h 39m · 77 g · 1 material(s)

  Prints on: P1S 0.4, X1 Carbon 0.4, H2D Pro 0.4, H2C 0.4, X1 0.4, P2S 0.4, P1P 0.4, H2D 0.4, H2S 0.4, A1 0.4, X1E 0.4, A1 mini 0.4, X2D 0.4, A2L 0.4PLA

  Not in stock