Cigarette Case Version 2 This is the tweaked version of my favorite project. The case holds 10 standard sized cigarettes . ( ~ 84x8mm) Five in the front compartment, and five in the back . It is now easier to assemble , features only standard components (M2 screws instead of some random nails i had lying around), is less complicated to print and requires less post-processing . What you need for the assembly: few drops of superglue 6x M2x16 cylinder head screws (DIN 912 / ISO 4762) Tips for printing: The different components are pre-oriented for optimal results I strongly recommend printing the hooks with PETG, or something similar flexible! check if the layer adhesion of your PETG is good. I encountered some issues in which the little arm of the hook broke off when closing the hatch. Please print a test hook and try to put some force onto the little arm to see if it holds up. (has to flex like max. 0.5 - 1mm) I increased the nozzle temp by 5-10°C, and reduced printing speed. This solved my issue. And of course make sure your filament is dry :) Tips for assembly: Glue the hooks into the hatches like this: Make sure the hooks lie flush with the surface (as indicated by the arrows) Apply glue only in marked area: The hinges are mirrored and get assembled like this: (red arrow → front of the case) Tighten the screws carefully , try not to strip the plastic :) Stop tightening once the resistance becomes too high or when the hinges have about 0.5mm of play. Boost Me I hope you will have fun with this little device, its definitely a conversation starter :) If you want to reward my work, you can boost me here! Thank you many times :) A little Bonus: In general I recommend to print the case from PLA or PETG. But I quite like the Bambu ABS-GF, so I created a second print profile for the ABS version. The model in the ABS Profile is slightly scaled up (~0.3 - 0.5%) , to compensate the shrinkage. This makes sure that the PETG hook will still fit with the rest. I had to support the hatches with a custom support structure, because the model warped and got loose during the print. (see in ABS print profile) And make sure to pre-heat the build chamber . like 90°C for 20-30min .

Cigarette Case V2

by cold. · original on MakerWorld ↗

♥ 1.1k⬇ 1.8k🖨 693 prints

Print profiles

• Standart - 0.16mm layer, 2 walls, 20% infill

  ⏱ 5h 16m · 61 g · 2 material(s)

  Prints on: P1S 0.4, X1 0.4, X1E 0.4, P1P 0.4, H2D Pro 0.4, A1 0.4, H2S 0.4, H2D 0.4, X1 Carbon 0.4, P2S 0.4, H2C 0.4, X2D 0.4, A2L 0.4PLA-CFPETG

  Not printable on our printers

• with custom support, scaled for ABS/ASA to counter shrinkage

  ⏱ 6h 4m · 63 g · 2 material(s)

  Prints on: P1S 0.4, H2S 0.4, H2D 0.4, X1 Carbon 0.4, A1 0.4, X1E 0.4, H2D Pro 0.4, X1 0.4, P1P 0.4, P2S 0.4, H2C 0.4, X2D 0.4, A2L 0.4ABS-GFPETG

  Not printable on our printers