Check out the print timelapse and support removal video here.
If you like this this one, check out my other string art models here.
This print is pretty difficult to set up properly so please just use the prepared 3mf file that contains custom supports and all necessary settings.
Not scalable. Must be printed with 0.2mm layer height.
Be very careful when removing the support. I recommend using pliers to break off each branch one-by-one.
Commercial License:
You can subscribe for a commercial license membership on my Patreon.
Overtaken
by Áron Pozsár · original on Printables ↗
Art & Design / Other Art & Designs
♥ 404⬇ 1.8k🖨 4 prints
Print profiles
overtaken_frame_stl.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
overtaken_main_stl.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
overtaken_frame_prusa.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
overtaken_main_part_prusa.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print