Installing a 🥰 BTT SB2209 on my Voron Stealthburner/CW2, I wasn't satisfied with the available umbilical solutions. So I started from scratch, explored different approaches, and designed this Cable Bridge PLUS.

It ended up not that different from existing models, but it's fine-tuned in the ways that matter most to me. And it pairs with a custom-made companion part - the XT30 2+2 Plug for SB2209 / SB2240 - to form a sleek and ultra compact umbilical solution for these toolhead boards. 🤩

Features

• Sleek, compact design - Clean look without low-profile cable runs 

• Secure cable management - Keeps everything tidy and strain-relieved

• PG7 Cable Gland support - Two thread variants: M12x1.5 and M12x1.25 to fit different PG7 glands

• Stepper motor cable cover - Protects the stepper cable that becomes exposed due to the rotated stepper motor

• Optional steel wire mounting - Screw-secured mounting point for the umbilical steel wire

Assembly

Just a short remark before we start:

• The part is designed for an umbilical cable with outer diameter of 5.5 mm.

• The mounting point for the umbilical cable is tight - this is on purpose to hold the cable securely also in heated environments, where the material of the cable coating might soften. So you will need to use some force to press it in. The shape of the part will allow it to flex slightly, helping you to get things done.

If your cable does not fit just drop me a message ... or use some sandpaper.

And now, just follow the pics ... and have fun building! 😎 

Pre-Assembly: Remove break-away support

Cable Bridge:

Optional: Nitinol / Piano Wire

Umbilical Wiring:

BOM

• 2 x M3x5x4 Heat Set Insert (Voron Spec)

• 3 x M3x8 Socket Head Scew

• Steel Wire: 1mm Nitinol Wire

Print Settings

Just use your standard VORON print settings.