Remix of H1+ case for Heltec v4 with space for 2 x 18650 batteries in two versions - with lodgement or without it.
Based on version for antennas up to 15mm in diameter at the base.
Needs 2 M3x12 if you planning to use clamp.
Best to use 26ga (0,14mm2) wire for wiring batteries
H1++ Case for Heltec v4 for 2 x 18650 battery
by AWHunter · original on Printables ↗
Gadgets / Portable Devices
♥ 135⬇ 1.5k🖨 11 prints
Print profiles
H1++ clamp.stl.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
H1++ buttons.stl.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
H1++ back.stl.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
H1++ back+lodgement.stl.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
H1++ front.stl.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print