There are several problems with the original case, this remix aims at solving them all:
- Can't enter dfu
- Can't connect and disconnect battery
- There is to little space for the battery (thickness)
- The battery pushes onto the gps cables it can lead to unplugging the gps
- The case uses M2.5 screws that can strip the plastic easily especially with the battery pushing the halves apart.
- There is no space around the antenna screw making securing it difficult
- Lots of sharp edges that are hard to print
Parts needed:
3x M3x12mm screw and CNC Kitchen M3x5.7mm brass inserts.
Check the list below to see full change-log.
3D-Printed Enclosure for Heltec V4（GPS）Fixed
by Tom_Ash · original on Printables ↗
Gadgets / Other Gadgets
♥ 118⬇ 1.0k🖨 6 prints
Print profiles
buttons.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
heltec-wifi-lora32-back_mod.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
heltec-wifi-lora32-front-mod.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print