This is a cool case.
Designed for Heltec WiFi LoRa 32 (V4) with GPS module support.
Hardware: 3000mAh battery, PCB, antenna, GPS module. Three M2.5×8 self-tapping screws required.
Personal use only. Commercial rights and custom design: [email protected]
Feedback welcome.
3D-Printed Enclosure for Heltec V4（GPS）
by Adi CEvil · original on Printables ↗
Hobby & Makers / Tools
♥ 149⬇ 2.0k🖨 7 prints
Print profiles
Heltec-Wifi-lora32-V4-WK-GPS.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
MdLE.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Button.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
BC-2.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
TC-2.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print