Recommended print settings:
- Material: Â PETG
- Layer Height: 0.20
- Infill % : 15
- Supports: No
- Print Orientation: Default as modeled.
As seen on Jelle Romers video:Â
 And article: https://www.sciencedirect.com/science/article/pii/S0141635921000726?via%3Dihub#appsec1
https://doi.org/10.1016/j.precisioneng.2021.03.002
And The Action Lab:
And on laughingsquid: https://laughingsquid.com/chicken-head-fixed-point-rotation-model/
Spherical flexure joints "Tetra 1" - no supports required. Remix, as seen on The Action Lab
by REMLURELMI · original on Printables ↗
Learning / Physics & Astronomy
♥ 80⬇ 711🖨 16 prints
Print profiles
Tetra1_pen_and_flexure.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Tetra1_pen.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Tetra1_6mm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Tetra1_Requiring_supports.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print