🖨️ Print Shop
Sink Drain Strainer

Fits 70mm drains, allows for good flow even when partially blocked.

Should be printed with heat resistant filaments if its going to be exposed to boiling water, I found that PETG and ASA will warp, while PC is able to resist warping with boiling water being poured over it.

Must be printed with supports. Can either be printed with the bottom facing the build plate or at 31 degrees tilt for better part strength.

Sink Drain Strainer

by efka88 · original on Printables ↗

Household / Kitchen

♥ 778⬇ 2.6k🖨 10 prints

License: Creative Commons — Attribution ↗filtersinkdrainstrainer

Print profiles

  • Sink drain strainer.stlDEFAULT

    ⏱ time and weight estimated after preparation · 1 material(s)

    Made to order: we prepare this file when you order, which adds a few minutes before printing starts.

    Prints on: A1 mini 0.4PLA

    Order this print