🖨️ Print Shop
Dell Wyse 5070 10-inch Rack Mount

This model was based on this work. but it has been redesigned to specifically fit the Dell Wyse 5070. I modeled this with a 0.5 mm tolerance.

Print Settings that I use:

  1. Infill: 13%
  2. Layer Height: 0.2 mm
  3. Material: PLA (I know it's not really recommended to use this type of plastic because it can warp from the heat over time, but it's the only filament type I have. \_(ツ)_/)

Dell Wyse 5070 10-inch Rack Mount

by NasiPadang · original on Printables ↗

Gadgets / Computers

♥ 56⬇ 516🖨 1 prints

License: Creative Commons — Attribution — Share Alike ↗dell10inchrackdellwysedellwyse5070

Print profiles

  • Dell wyse 5070 1U 10 inch rack.stlDEFAULT

    ⏱ time and weight estimated after preparation · 1 material(s)

    Made to order: we prepare this file when you order, which adds a few minutes before printing starts.

    Prints on: A1 mini 0.4PLA

    Order this print