A form-fitting snap together case for the Heltec v3 meshtastic radio with OLED display that fits a makerfocus 3000mAh battery nicely. It's a close fit, so take your time putting it together. I tried to adjust some tolerances to make it a little more forgiving as I cracked the display the first time I was putting it together. The antenna wire routing slot helps with that since you don't need to run it around underneath the board. A thumbnail or guitar pick or other small spudger-type device is best for getting it open when needed.
Heltec v3 case for 3000mAh battery
by Matt Smith · original on Printables ↗
Gadgets / Portable Devices
♥ 61⬇ 1.1k🖨 7 prints
Print profiles
Top with tabs.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Bottom.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print