Would you like to support my work? :)
Check out my  full catalog with exclusives, early access and commercial licences.
— 

An organic shelf that “grows” from your wall.

If you need a small shelf for anything you want to make visible every day (like your favorite Benchy or a small plant) this is the one for you.

Versions

• Oysterfungus_shelf_default: The default size

• Oysterfungus _holder_default: the holder for the default size with a screw-hole diameter of 5.5mm

• Oysterfungus _shelf_small: A mini version (60% scale)

• Oysterfungus _holder_small: A holder for the mini version – simply scaling down the default version would make the holder unusable

• Oysterfungus _shelf_no_holder: The Shelf without the cut-out intended for scaling down below the mini version – must be mounted with glue or tape

• Oysterfungus _holder_for_upscaling: If you want a huge version, scale up the default shelf and use this holder – the only difference is the screw-hole size of 3mm that will be usable when scaled. 

• Oysterfungus_shelf_magnet_internal: A version for making a fridge magnet with mid-printing insertion (40% scale)

• Oysterfungus_shelf_magnet_external: A version for making a fridge magnet (40% scale)

Instructions

• Print the shelf and holder

• You can either screw or glue it onto your wall. There are various glue or tape products for wall fixation out there. I used 3M Tape. Old fashioned screws and dowels are the most reliable fixation.

• Insert the shelf by moving it horizontally onto the holder until the holder is completely inside the cutout. Then proceed to move the shelf down and the holder locks.

• Enjoy!

Instructions fridge magnet

Magnet required: a 20 x 2 mm neodymium magnet

Internal magnet

• The internal magnet shelf file has a cutout inside to place a magnet during the printing process. All mushroom wall shelf designs have the cutout at the same height – so you can print all of them at the same time.

• Use a copper nozzle for printing (nonmagnetic)

• Slice the file and check the layer height of the last layer before the bridging over the hollow cutout starts. With a 0.4mm nozzle it should be at layer 15. Implement a pause after that layer with your slicer.

• Start the print

• At the pause insert the magnet and continue printing. As always be careful with magnets and electronic parts!

External magnet

• Print the file

• Glue in the magnet after the printing process – the cut-out is sized to let the magnet stand out just a bit

Size default assembled: 100 mm x 155 mm x 160 mm

Print settings

Required build volume: 160mm x160mm x 120 mm

Material usage: 130g

Print time: 11h

Material: PLA

Print direction: stls are rotated correctly, check images

Support: none

Nozzle size: 0,4 mm

Line width: 0,4 mm

Layer height 0,2 mm

Outer walls: 3

Infill: 15%

Build plate adhesion type: none