AC Power Cord splitter (Kettle Cord) mk1
This was part of my 3D Printer enclosure projects to tidy up the cables on the back of the enclosure.
Uses a standard ‘chocolate bar’ electrical connector
This design comes with:
The body of the splitter
clip-on top (screwless)
a cable-hole top that can be screwed on (3M).
a hole plug in case you don't need all 4 extensions.
Cable hole diameter: 7mm
Blender 4.2 Used.
Note: I tried printing this with ABS first. However it's -7 degrees (C) outside so it warped. I had little patience so I printed it instead with PLA+ (the print in photo). ABS printed better (except for the warp) but, I think it might have something to do with the print settings not being adapted to the new enclosure yet - I will play with the settings a bit more. Anyway: PLA worked fine although I still believe ABS would be better.
AC Power Splitter
by Vector Connections · original on Printables ↗
Gadgets / Computers
♥ 44⬇ 4.1k🖨 0 prints
Print profiles
AC_power_splitter_box_body.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
AC_power_splitter_box_lid.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
AC_power_splitter_box_cabletop.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
AC_power_splitter_box_holePlug.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print