The belt is flexible and small to fit into medium to large holes. Also conforms well to both external and internal fillets
I suggest using 200-600 grit, and printing with PETG.
Model is slicer scalable, although provided scale gives the best results. Scaling will impact fillets which may not look as good.
WARNING:
Make sure your sandpaper is strong and does not rip with a reasonable amount of tension. Folding the paper over itself helps a lot with strength, although cut-up belt sander belts work best. 10mm*150-180mm.
If your belt ends up being top thick, scale down the front and back holder pieces in the slicer. Turn off uniform scale. Scale down by an extra 0.1mm-0.2mm in X and Y but not Z (vertical axis).
Handheld Tension Sander
by Magmabow · original on Printables ↗
Hobby & Makers / Tools
♥ 2.8k⬇ 4.1k🖨 30 prints
Print profiles
BackHolder.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
FrontHolder.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
MainBody.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print