Reformed the clamp, so it closes all the way and also deforms the cable to be able to also clamp very thin wires.
The base must be printed together with the clamps (print in place). The single files of the base and the clamps are only for recreation and adoptation of the clamps in combination with the OpenSCAD file.
Category: Hand Tools
Wire Soldering Station
by grafmar · original on Printables ↗
Hobby & Makers / Tools
♥ 617⬇ 2.9k🖨 42 prints
Print profiles
wiresolderstation.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
clamp.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
substract.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
base.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Spring.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print