Cool little set of planetary gears I threw together as a proof of concept
*NEW* 3 Geared Variant
*NEW* 5 Gear w Shafts
| Printing Settings |
- MUST be printed at a LH of .25mm or less
- MUST not be scaled down, unless your printer can handle ridiculously small tolerances
- MUST reduce the “Slice Gap Closing Radius” setting
- Scaling up is really cool but it can result in a wobbly fidget
- Set seams to the smaller side to prevent crunchy gears
- Tougher filaments tend to yield better results
Note - The shaft variant needs 5 E-Clips to stay together
Happy Printing!
Planetary Gear Fidget *UPDATED*
by TroutThing · original on Printables ↗
Toys & Games / Other Toys & Games
♥ 322⬇ 3.0k🖨 19 prints
Print profiles
Planetary Fidget - 5 Gear.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Planetary Fidget - 3 Gear.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
5 Gear w Shafts - Shaft Collector.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
5 Gear w Shafts - E-Clip.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
5 Gear w Shafts (1).stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print