Its an Turbine blower remix to fit an 775 motor. The original is from JolietDelta.

I improved the design to fit an 775 motor. Also the turbine is a lot bigger than the original, the parts fit on an 200x200x100mm (LxBxH) bed. You can press-fit M5 Nuts into the base of the Model an screw it down with M5 bolts, so the parts are secured.

Category: Other

Turbine blower motor 775

by 3D-aniel · original on Printables ↗

Hobby & Makers / Other Ideas

♥ 450⬇ 2.4k🖨 2 prints

License: Creative Commons — Attribution — Noncommercial ↗motorcarturbineturboblowerthingiversewindturbineturbofanturbochargerturbinesturbojet

Print profiles

turbine_775_korpus.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
turbine_775_grundplatte.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
turbine_775_schaufelrad.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print