The profile is for printing at .16mm layer height. I had done .20 but the right claw kept failing for some reason. I also have the infill at 40% just to try to ensure taking off supports on the claws won't ruin them. You can get away with a lower infill but do so at your own risk. Shin Godzilla is one of the coolest-looking Godzillas and I was happy to turn this into a printable model. It was scanned from a figure by Laser Design on Sketchfab and they have been properly credited. I love Godzilla models, and this one is unique and I am happy to share it with everyone and make it a physical model we can all enjoy! I hope you print it and enjoy it!