I tweaked McGybeer's the design and added a loops to make the baby shark into hoody beads. I also attached the tail to the last body segment and made it so that it prints vertically as at the half scale I could't get the tail's ball joint to work. The side fins are aslo mostly stationary not due to the loop connection. All the other joints worked though including the mouth, which I was a touch surprised at.
My Prusa hoody has taken a bit of a beating.
Baby Shark Hoody Beads
by Ian Foulds · original on Printables ↗
Fashion / Other Fashion Accessories
♥ 411⬇ 946🖨 1 prints
Print profiles
BabyShark_Beads_5mm.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
BabyShark_beads.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print