Power plug beads to put in the end of cords or laces.

Assamble guide:

-Print the model as shown in the pictures in 0.16 mm or lower with supports. I printed mine in 0.12 mm woth a 0.4 nozzle.

-Remove the supports and all imperfections carefully with an exacto knife.

-Cut 4 pieces of filament of aproximatedly 5 mm for each model.

-Make a knot at the end of the cord and cut any small threads that could get in the way.

-Assamble the two halves and press firmly.

Power plug beads

Fashion / Other Fashion Accessories

♥ 1.4k⬇ 1.4k🖨 5 prints

Print profiles

PowerPlugBead_Down.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
PowerPlugBead_Up.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
PowerPlugBead_Right.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
PowerPlugBead_Left.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print