1. Set Infill to 0%
Go to Print Settings → Infill → Set to 0%
This removes the internal fill, but the walls remain thick.
2. Adjust Wall Thickness
In the Shell / Perimeters section, modify the wall thickness:
Wall Loops / Perimeters – set to 2–3 layers (e.g., 1.2–2 mm thick).
Top/Bottom Layers – if you want an open bowl, remove the top layers.
Spiral Vase Twisted Spiral Vase Vase Spiral Vase Spiral Vase Flower curved vase Flower vase vase vase vase vase vase vase
by z s · original on Printables ↗
Household / Living Room
♥ 600⬇ 6.3k🖨 30 prints
License: Creative Commons — Attribution ↗vaseflowerspiraltwistedvasemodeflowerpotspiralvasespiralvasemodeflowervasetwistedvasehomedecorflowervasesspiralvaseprintingspiralizedwavyvaseviralparametricvasemodernvasehomeaccessorystylishvasevase3dprint3dprintedvaseprintablevase
Print profiles
Spiral Vase IP.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print