I needed a simple stand for an additional Home Assistant Raspberry Pi kiosk I am adding to my home – so I whipped this up.
You’ll need some 2.5mm screws for assembly (I used socket head cap screws). Add some rubber stick-on pads to keep it from sliding around. I printed the two supports with 3 walls to give a little more structure to the holes.
Printed with Eryone Galaxy Purple and Black PLA.
Display purchased from Amazon:
https://www.amazon.com/dp/B0D3QB7X4Z?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
*** 01-31-2026 Case with Switch Access Added ***
Finger access added for backlight switch.
Hosyond 7” Touchscreen DSI Display Case / Stand for Raspberry Pi
by lanwanman · original on Printables ↗
Hobby & Makers / Other Ideas
♥ 58⬇ 924🖨 6 prints
Print profiles
Hoysond_Support_7_Inch.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Hoysond_Case_7_Inch.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Hoysond_Case_7_Inch_Access.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print