Material - PETG (PLA should work too, ABS - probably not)
Hardware required
M8 nuts - x4
M8 bolts (40mm) - x4
Square steel pipe 300x25x25mm - x2, plans attached.
M8 eye bolt + M8 nut - x2, if you want to add attachment rings.
Printing
When printing add 100% infill modifiers to theese areas.
Place supports manually, and only here. Everything else is designed to be printed with no supports.
You can probably replace steel pipes with printed parts, although I have not tried it myself.
Pillory
by 626abad71b · original on Printables ↗
Costumes & Accessories / Other Costume Accessories
♥ 154⬇ 874🖨 0 prints
Print profiles
pipe_replacement (print with 100% infill).stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
hand 65x55.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
neck 140x140.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
long_key.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
key.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
pillory_inplace.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print