The speaker enclosure has a volume of 4.5 liters and is tuned to 60 Hz. It features a triangular port design, eliminating the need for support structures during printing.

Crossover:

I designed my own crossover based on online measurements, but the tweeter turned out to be more efficient than expected. To fix this, I used a DSP to lower the highs. I adjusted the resistors in the picture to bring them to the right level. If you can’t find the exact resistor values, similar ones will work just fine."

The 1.2 µF capacitor functions more like a bypass capacitor, so it's best to use a high-quality film capacitor. For my build, I used only film capacitors and air coils, and for the bypass capacitor, I chose a ClarityCap ESA. All components, including the drivers, were sourced from SoundImports.eu

The speaker drivers used are:

Dayton Audio RS125-8 Woofer

HiVi SS1II Dome Tweeter

However, if you use a tweeter with a similar impedance curve, you could likely try it as well.

Tutorial:

Use damping wool inside the enclosure and, optionally, apply some Alu-Butyl on the inner walls for additional wall vibration/resonance reduction.

The baffle includes slots for six M3 and M4 nuts. To assemble, install the drivers into the baffle, place a nut into each slot, insert a screw, and lightly tighten it. Repeat this process for all slots, and finally, securely tighten all screws.

Apply silicone or any non-quick-drying adhesive into the groove to ensure a strong bond between the enclosure and the baffle.

Crossover Components:

Resistors: R3 1.5 Ohm, R2 8.2 Ohm, R1 7.5 Ohm.

Air-coils: L2 0.18mH, L1 0.95mH.

Film-capacitors: C4 1.2uF, C3 12uF, C2 8.2uF, C1 12uF.

Updating:

I plan to update this design in the near future, so be sure to check back for updates!

Last updates: 

-  Update improves crossover phase response

-  Update fixes tolerances issues so it works with worse printers

Support my work on Patreon for exclusive content and to help fund future projects, including free public releases:
👉 patreon.com/Hexer3D

By supporting me, you not only gain access to exclusive content but also contribute to the development of innovative projects and free resources for the community. Your support makes all of this possible—thank you! 🙏

💰 Just want to leave a tip? You can do so here:
👉 PayPal Pool