As seen on X and YouTube:
Designed for use with a pair of the Dayton Audio TCP115-8 4" midbass drivers, and a Dayton Audio DS175-PR 6.5" passive radiator. The two drivers should be wired in parallel, with the forward driver wired out of phase. Use M4 threaded inserts 6mm deep / 6mm outer diameter, and reusable adhesive to seal around everything. Set the high pass no lower than 45Hz, low pass around 80Hz. ~10W should be enough for it to play at volume. The companion pods should only need a ~100Hz high pass filter.
Midbass Drivers:
https://www.parts-express.com/--295-416
Extended Range Drivers:
https://www.parts-express.com/--295-349
Passive Radiator:
https://www.parts-express.com/--295-498
Threaded Inserts:
https://www.amazon.com/gp/product/B0CS6XGMFD
Screws:
https://www.amazon.com/gp/product/B0BMQ4WV1V
Binding Posts:
https://www.amazon.com/dp/B07PFMD1N2
Recommended printing settings:
PLA is okay; PETG is better.
At least 4 walls (perimeters) all the way around.
At least 20% gyroid infill. (Higher is better; this thing WILL vibrate.)
Print the handles 100% solid.
Disclaimer: This is an acoustic model. As such, it does not scale, nor is it compatible with drivers other than the ones specified. Scaling / incorrect driver(s) will result in significantly diminished performance.
HexiBox Series: Motor
by HexiBase · original on Printables ↗
Gadgets / Audio
♥ 413⬇ 1.1k🖨 2 prints
Print profiles
Handle Plate.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Companion Pod.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Shell - Front.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Shell - Rear.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Vent Extension.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Internal Baffle.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print