Quick print glasses for New Year's 2025!
Remix Info
Primary new thing here is the filament hinge inspired by a different shutter shade remix. The original openscad design was really good but the snap-fit arms were very fragile. I used blender for some booleans then did manual reinforcement of the hinge portion and added a nose bridge. Turned out nice. Created sizes for adults, teens, kids, and toddlers from this size chart.
Source models:
- My 2024 design
- My 2023 design
- My 2022 design
- Hinge inspired from thing:4703203 by nutshell
- Customizable
openscadthing:1603773 by drjames - Original shuttershades design thing:28706 by cmcnamara
Printing
Use small segment of 1.75 mm filament for the hinge; heat with soldering iron or similar to solidify. You can use a 2mm drill bit if the holes are a bit snug. They are modeled at 2mm so it just depends on your printer.
PLA is fine if you are gentle but the hinge is stronger with HTPLA/PETG etc. If you have the textured bed you may want to use that so the surface finish is nicer. I do recommend using “don't cross perimeters” setting to reduce PETG stringing (enabled in the 3mf).
2025 Shutter Shades
by Teque5 · original on Printables ↗
Fashion / Other Fashion Accessories
♥ 673⬇ 2.9k🖨 45 prints
Print profiles
2025_new-years-glasses_adult.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
2025_new-years-glasses_junior.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
2025_new-years-glasses_toddler.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
2025_new-years-glasses_teen.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print