Made to fit an Ender 3 V2 print bed (235mmx235mm) when rotated to face a corner.
How to Print
Scaling
Scale to 10000% for a ~140mm wide head (or 9750% w/ heat gun to reshape the back)
- roughly 200mm x 229mm x 166mm (xyz) w/ opening facing forward
Print Settings
- Nozzle size: 0.4mm
- Layer Height: 0.2mm
- Enable tree supports
- Positioning:
- Rotate and angle to fit the print bed (see photos).
- Raise print off bed for supports to generate beneath
Antler points may break off when printed fully vertical :(
Minos Antlers Reduction (Crown Version)
by Xajerax · original on Printables ↗
Costumes & Accessories / Cosplay & Costumes in general
♥ 457⬇ 932🖨 3 prints
License: Creative Commons — Attribution — Noncommercial ↗cosplaycrownender3natureantlersdruiddryadantlerender3v2headpieceminos
Print profiles
Antlersblend_reduction.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print