Improved V2 - better hairband connector see: https://www.printables.com/model/1446163-horns-on-hairband-v2
The horns have a tight fit on the hairband so that you can adjust the position as you like, no glue needed.
Horns printed in PLA (matt PLA was used for the pictures)
- both 0.1 or 0.2 mm layer height should work.
- 15% infill is sufficient for having good stability at the base
(you can add a modifier with 0% infill at 60mm height) - for best quality print horn separately
Hairband PLA or PETG
- both 0.1 or 0.2 mm layer height should work.
- no infill needed
- organic support for the connectors
Hairband adjustments:
- too narrow … try to gently bend it in your hands
- too long … cut the ends with a cutter knife or side cutter and sand the sharp corners
Horns on hairband
by manmac · original on Printables ↗
Costumes & Accessories / Cosplay & Costumes in general
♥ 543⬇ 1.9k🖨 17 prints
Print profiles
Devil horns left.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Devil horns right.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
hairband.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print