It works with 9gr micro servo. A single servo or two separate servos can be used.

Material: PLA
Print setting: 3 walls and full filling

2.5mm steel rod can be used for struts.
4 pieces of M2.2 or 2.3 (Length 6-9mm) screws are required.

Suitable for models with a flight weight of less than 900gr.

----

9gr mikro servo ile çalışır. Tek servo veya iki ayrı servo kullanılabilir.

Malzeme: PLA
Baskı ayarı: 3 duvar ve tam dolgu

İniş takımı dikmeler için 2,5mm çelik çubuk kullanılabilir.
4 adet M2.2 veya 2.3 (Uzunluk 6-9mm) vida gereklidir.

900gr'dan az uçuş ağırlığına sahip modeller için uygundur.

Folding Landing Gear for RC Airplane

Hobby & Makers / RC & Robotics

♥ 147⬇ 1.9k🖨 2 prints

Print profiles

Servo Retract 2_3 mil - Strut part2.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Servo Retract 2_3 mil - Arm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Servo Retract 2_3 mil - Body 1.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Servo Retract 2_3 mil - Body 2.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Servo Retract 2_3 mil - Strut part1.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print