A handy device for pressing bricks of ground flower for your PAX 2/3/Plus vaporizer.

There's an original version from the vape manufacturer for the same purpose, but that one sucks:

• it's extremely brittle and breaks after not that many uses
• at $25 it's absurdly overpriced for a bunch of tiny pieces of cheap plastic with a few magnets

Actually purchased the original part at first, only to have it break on me super fast. So I reconstructed the thing to be able to make a cheap replacement. It doesn't have magnets which make the original part very comfortable to use, but whatever. It does the job, and if you put a small rubber band around it, the parts will stay together too.

Print instructions

• PETG
• 0.4mm nozzle
• 0.2mm layer height
• 5 perimeters
• 25% Infill, Honeycomb
• Ironing on, all top surfaces
• No supports needed

You best print every part separately to avoid excessive stringing.

The Pax logo on the tube part in the photos was simply painted with a waterproof marker.